Automatic Mist Propagation designed for professional and amateur grower creating the best enviornment for rooting cuttings.You need electricity and mains or pumped water and a Bench or Overhead Mist System.The leaf sensor regulates the frequency of mist. Once evaporation breaks the circuit on the leaf sensor the solenoid valve opens and misting starts, continuing for 1 to 30 seconds (setable) controlling the wetness of the crop from each misting.Leaf sensitivity adjusts the amount the leaf sensor dries before misting again. The combination of the two settings gives infinitely variable control. The unit can be switched to continuous mist and from burst time in seconds to minutes enabling it to be used for watering.Mist pre-wired, mains plug, Leaf Sensor & 24v Solenoid Valve all on 3 mtrs cable. Tap Connector. Sixe 170 x 80 x 65mm.
Supplied with2 mtrs High Pressure Hose, Clip and Adaptor to garden hose. Covers 3' dia: run of bench. Mist Nozzle, fitted with filter and mounted on a stainless steel stand.
Nozzle and stand covers a further 1 mtr. 2mtrs of high pressure hose, tee & clips.
Mist covers a 3ft x 6ft area. Consists of two nozzles, 15mm rigid pipework, hose connection, wire hangers, push fit fittings for easy disconnection if changing layout or adding extra nozzles.
Modern commercial Nozzle. For replacement of old brass type. UV stabilised plastic, stainless steel jet and anvil, mesh filter and non drip valve. 1/2" BSP male thread. At 50 psi. 0.6mm JET 3' dia: uses 0.42 ltrs per minute.
60 psi 240V diaphragm pump. Will run a Mist System producing a fine mist from rain waterbutt or RO water tank. Runs up to 10 mist nozzles. Will also run our Trigger Lance or small watering system from a waterbutt.
